Large angle conveyor [1] from the baseband, ribs, transverse bulkhead 3 parts. Ribs measure to prevent the material from sliding spilled role. For ease of bypassing drum gear corrugated edge design; the role of the crossbeam is supporting material, in order to achieve large transmission angle, using T-TC type. Gear side and transverse bulkhead is a secondary vulcanization method and baseband connection with high connection strength product characteristics (common-steep corrugated sidewall conveyor belt): 1, increasing the delivery angle (30 to 90 degrees ); 2, small footprint, less investment; 3, throughput, and enhance greater heights; 4, inclined from the horizontal (or vertical) smooth transition; 5, suitable for transporting easily scattered powder, granular, small block, paste and liquid-like materials; 6, low energy consumption, simple structure, high tape strength, long service life. Large angle corrugated wall zone Use 1. In use, is strictly prohibited in different categories with different specifications of the tape, connected together. 2. To prevent folding in use, the hard phase pressure. Should coiling use and storage. 3. The transport of materials and material direction of the falling speed and direction and speed of the tape with the same. 4. Before using a general first empty machine running, so as not to overload the motor and large angle conveyor belt slippage, before stopping, the tape should be emptied of all materials. 5. When using the tension should not be too large to be with the drive roller does not slip and transition material is not the premise of guaranteed work under minimal tension. 6. Do not allow the delivery of the tape deviation or meandering run, should be timely adjusted. 7. slipping phenomenon or pull them in use, should be timely troubleshooting, adjusting the tensioning system to keep flexible elastic means.